Installation and debugging method of 100 ton CNC hydraulic bending machine die?

Release time：2021-10-12　　　　 Browse times

The mold of 100t CNC hydraulic bending machine is composed of many parts, so special attention should be paid to installation, and repeated debugging should be carried out when it is completed. Generally, when we install and adjust the bending machine die, it will be divided into five parts.

1. For the adjustment of the machine, before installation, first adjust the performance of the machine. This process must be patient and serious, check whether the machine has dust and used iron debris, and carry out necessary cleaning to reduce the trouble in the later stage.

2. For the adjustment of the slider stroke, pay attention to check the thickness of the die and whether the proportion of the upper and lower modules is normal. Normally, the module should be controlled at the switching point of the stroke line, which must be paid attention to.

3. The adjustment of the travel module is to adjust the upper limit point of the module. When the module goes up to the highest point, set the switch and reserve the stay position of the slider. At the same time, the deceleration module should also be carried out when it goes down to better protect the machine and bending machine die.

4. The gap adjustment is mainly to measure the distance between the upper module and the lower module. The specific gap setting is determined according to the folded plate.

5. Angle adjustment. This angle adjustment has a certain relationship with the product. Generally speaking, when folding the 90 ° mold, the middle angle must be greater than the angle on both sides, and its tightness can be adjusted according to the adjusting screw. During bending, the pressure can be adjusted through the pressure gauge to avoid die edge collapse.

The above is the method of correctly installing and debugging the bending machine mold of 100 ton CNC hydraulic bending machine. I hope it will be helpful to you. The mold of 100t hydraulic bending machine is divided into upper mold and lower mold, which is used for sheet metal stamping and separation.